Sewing/Troubleshooting

The machine is skipping stitches, making thread snarls below the fabric, or making grunting noises

Most likely the needle needs to be changed. Also make sure it's the right type of needle for the material you're working with.

If that doesn't fix it, try rethreading the top thread. Make sure to raise the foot before you do that and put the foot back down after.

If that doesn't fix it, see the next section.

The machine isn't making stitches at all

Things to check/try in ascending order of fix difficulty:

• Make sure the foot is down. Upper tension is not engaged (upper thread will not feed) when the foot is up.
• Try rethreading the upper thread.
• Check the bobbin; make sure the lower section is clean and free of snarled threads.
• Make sure the bobbin is the right type for the machine you're using.
• Try winding a new bobbin (appropriate for the machine you're using) off of the bobbin you're using.
• Try replacing the needle.
• Check the upper thread tension. For most projects it should be on one of the middle few settings.
• With the needle threaded, bobbin installed, and foot down, turn the handwheel (always towards you) one full cycle to test whether it makes a stitch without fabric.
• Try the same thing with regular cotton or polyester thread and woven cotton fabric, if that's not what you were already using. *You might need different settings, a different needle, or a different foot for your project.
• Unthread the needle, take out the bobbin, and turn the handwheel (always towards you) to check the bobbin timing. The bobbin hook should pass behind the needle about when the needle is descending. (If it's not obviously wrong, it's probably right.)
• Worst case is bobbin timing or lower tension might need to be adjusted, but those are last resorts. Don't try to do these yourself; alert a maintainer.

The material isn't feeding through

For thick stacks of fabric (cotton, denim, polyester, etc.), the presser foot pressure may need to be decreased. Remember to set it back to what it was when you're done.

For thin fabrics, the presser foot pressure may need to be increased. (The presser foot presses your workpiece into the feed dogs, so if the fabric is too thin and the pressure too light, the feed dogs may not grip.)

For sticky materials such as leather or (especially) vinyl, you may need a roller foot or a walking foot.