Discourse/Uncategorized/2019-05-29 Want to 3D print my groovy design

From Noisebridge
Revision as of 02:03, 28 March 2026 by Nthmost (talk | contribs) (Discourse archive import: Want to 3D print my groovy design [uncategorized])
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to navigation Jump to search

📜 Discourse Archive
This page is preserved verbatim from discuss.noisebridge.info, the Noisebridge community forum that operated roughly 2018–2022. The original site is defunct; this content was recovered via the Wayback Machine and is archived here as a primary source for Noisebridge history.
⮡ Original URL: https://discuss.noisebridge.info/t/want-to-3d-print-my-groovy-design/880
📦 Verify on Wayback Machine
📅 Archived: 2022-05-19
🏷 Original category: Uncategorized

Want to 3D print my groovy design

[edit | edit source]

Julee — 2019-05-29

Hiya. I drew up a 3-piece canister in Fusion 360. After several iterations with designers, I am now ready to print what I have. I haven’t 3D printed anything before. I’m so excited!

I’ve read through the instructions, here: https://www.noisebridge.net/wiki/3D_Printing#Printing_on_your_own_computer

So I’m going to get an SD card, install software on my computer, and download the 3D logo from Thingiverse. But I’m wondering a few things:

- Is there a better time to come around and print. It would be nice to have someone whom I could ask question if I get stuck?

- Has someone organized a Replicator Wednesdays?

- Should I bring anything besides the SD card? Like filament or tape?

- Which printer is good to start with?

Thanks for any tips, here. So looking forward to it!


David — 2019-05-29

FyI I believe the only functioning printer is monoprice mini. There has been some talk about fundraising for a creality cr10. Just make sure your object is small enough to fit. I think the mini bed is like 100mm^3.


mpmckenna8 — 2019-05-29

There’s currently a big roll of PLA working in the printer, the only thing to remember with sd cards for the mini is they should be partitioned into 4 gb or less if they are bigger than 4 gb because the mini can’t handle the big blocks.


David — 2019-05-29

Use PLA not ABS. Should be lots of PLA around the 3d printing area.

Retrieved from "https://main-wiki.extremist.software/index.php?title=Discourse/Uncategorized/2019-05-29_Want_to_3D_print_my_groovy_design&oldid=89660"